Question 1

How much does a concrete retaining wall cost?

Accepted Answer

Engineered retaining walls commonly price in the tens of dollars per square foot of wall face, driven by height, material, access, and the drainage system behind the wall. Small landscape walls land in the low thousands; structural replacements reach five figures. Every quote here is written and fixed. Retaining wall pricing scales with physics: the pressure behind a wall grows quickly with height, so cost per square foot of face rises as walls get taller, and a wall twice as tall is much more than twice the wall. The drivers stack predictably. Height and surcharge: a 3-foot garden terrace and a 6-foot cut holding a driveway above it are different structures, and anything over about 4 feet, or under a surcharge at any height, carries engineered design as both good practice and a permit requirement in most corridor cities. Material: segmental engineered block, poured concrete, and stone facing price differently, and the right choice follows the height, the look, and the budget. The invisible system: free-draining backfill, filter fabric, a perforated drain that daylights, and weep holes are a real share of the cost and the entire reason the wall will still be plumb in fifteen years; a bid that is silent on drainage is a bid for a future lean. Demolition: replacing a failed wall adds tear-out and haul-off, and failed walls usually failed because the drainage was never built, so the rebuild includes what was missing. Access moves labor: a walk-out backyard versus a lake slope at Kiowa or Texoma changes the equipment story. The free walkthrough measures all of it, and the written quote prices the wall you actually need, drainage included.

Question 2

Does a retaining wall need a permit?

Accepted Answer

In most corridor cities, yes above 4 feet of height, and engineered design is required with the permit. Walls under 4 feet with nothing pushing from above are commonly exempt in town. On unincorporated county land there is typically no permit, but the physics still apply. The 4-foot line comes from the building codes most area cities adopt: retaining walls over 4 feet measured from the bottom of the footing, or walls of any height supporting a surcharge (a slope, a driveway, a structure pushing from above), require a permit and a design sealed by a licensed engineer. Sherman, Denison, McKinney, Anna, Melissa, and the other incorporated cities in the corridor follow this pattern through their permit portals; Durant and the Oklahoma towns run their own equivalents. Under 4 feet with no surcharge, cities commonly treat walls as landscape features and exempt them, though HOAs and lake-community rules (Lake Kiowa's POA, Texoma shoreline oversight) can add their own review. On unincorporated Texas and Oklahoma county land there is generally no residential permit at any height. The important honesty: the permit threshold is not an engineering threshold. A 5-foot wall on unpermitted county land carries exactly the same soil pressure as one in town, and saturated Blackland clay pushes hard enough to rotate an undersized wall regardless of jurisdiction. So the rule here is simple: over 4 feet or under load, the wall gets engineered design wherever it stands, and the written scope names the permit path (or the absence of one) for your specific address, with the engineering handled inside the scope.

Question 3

What drainage belongs behind a retaining wall?

Accepted Answer

Free-draining gravel backfill against the wall, filter fabric between gravel and soil, a perforated drain pipe at the base that daylights downhill, and weep holes through the face. Never native clay packed against the wall: saturated clay is what pushes walls over. Walls do not usually fail from weak blocks or thin concrete; they fail from water, and the drainage package is the difference between holding soil and holding a pond. The system has four parts that work together. Free-draining backfill: a column of clean gravel directly behind the wall gives water a fast path down instead of letting it stack up as pressure; backfilling with the native clay that came out of the cut is the classic homeowner-special mistake, because saturated Blackland clay is both heavy and expansive, a double load the wall was never sized for. Filter fabric: a geotextile between the gravel and the retained soil keeps fines from migrating in and clogging the gravel over the years, which is how good drainage quietly becomes no drainage. Collection and exit: a perforated pipe at the base of the gravel column collects the water and, critically, daylights somewhere downhill, because a drain with no exit is a French drain-shaped decoration; weep holes through the face add a visible backup path. Surface management: the grade above the wall slopes away, and roof or slope runoff is routed around the ends rather than over the face. On taller engineered walls, geogrid layers tie the wall into the retained mass, and the engineer's drainage detail is part of the sealed design. Every wall scope here itemizes this system by name.

Question 4

Should a cracked retaining wall be repaired or rebuilt?

Accepted Answer

Repair is honest when the failure is local: a shifted cap, one cracked course, a clogged weep hole, on a wall still standing plumb. A wall leaning past plumb, cracked through its structure, or bulging from failed drainage is a rebuild, because the cause has to be fixed, not the symptom. The repair-or-rebuild call comes down to one question: is the wall's structure still doing its job, or has the load already won? Signs that favor repair: the wall stands plumb, the crack is isolated (a corner, a single course, a cap row), the footing has not moved, and the drainage behind the wall still works or can be locally restored. Those are maintenance events, and pricing them as maintenance is the honest answer. Signs that end the conversation: a lean you can see or measure (a wall past plumb is being rotated by pressure it cannot resist), a horizontal or stair-step crack running through the structural courses, a visible bulge or belly, soil washing through the face, or a wall whose backfill was native clay with no drain, because that wall is fighting a load it was never built for and every wet season moves it further. Patching a leaning wall buys appearance, not time. The rebuild scope does what the original should have: correct footing, engineered structure where height or surcharge demand it, gravel backfill with fabric and a drain that daylights, and surface grading that routes water around the wall instead of into it. At the walkthrough we measure the lean, probe what is behind the wall, and tell you plainly which side of the line your wall is on, with a written fixed price for that answer rather than the bigger one.

Question 5

What causes retaining walls to lean?

Accepted Answer

Water, almost every time. Saturated soil is heavier and pushes harder, expansive clay swells against the wall as it wets, and a wall built without gravel backfill and a working drain carries pressure it was never sized for. Undersized structure and surcharge loads finish the job. A leaning wall is a physics report. The pressure on a retaining wall comes from the soil behind it, and that pressure is not constant: it rises sharply when the soil saturates, both because wet soil is heavier and because water that cannot drain becomes hydrostatic pressure pushing directly on the wall. North Texas adds its own multiplier, because the Blackland clays on the east side of the corridor swell as they take on water, loading the wall again with each wet season and relaxing each drought, a cycle that ratchets an under-drained wall outward year over year. The failure chain is usually built in on day one: native clay packed against the wall instead of free-draining gravel, no filter fabric, no perforated drain (or one that never daylighted), and surface grading that sends roof and slope water directly into the backfill. Add the structural shortcuts (a footing too small for the height, no geogrid on a tall wall, a wall built casually under a surcharge like a driveway or slope above) and the lean is only a matter of seasons. Frost heave, the classic northern culprit, is a minor player here; our freeze depth is shallow. The diagnosis matters because it writes the fix: a rebuilt wall gets the drainage and the sizing the first one skipped, which is why rebuilds here itemize the invisible system, not just the visible face.

Retaining Walls & Drainage in Sherman

Veterans, Seniors, and First Responders Discount

What this service covers

A retaining wall is a drainage system that happens to hold dirt

Service area

Ready to get started in Sherman?